Hobart Champion 4500 manual Operating Auxiliary Equipment, Generator Power Panel Receptacles

SECTION 6 – OPERATING AUXILIARY EQUIPMENT

NOTE

The welding generator provides power while welding and with the Current control in any position. However, under these conditions equipment connected to the welding generator may be subject to larger than normal voltage fluctuations. It is recommended that only lamps be powered under these conditions.

6-1. Generator Power Panel Receptacles

1 2 3

YUse GFCI-protected extension cord.

.Generator power decreases as weld current increases.

Set Amperage control at max. for full generator power.

1240 V 20 A AC Duplex Receptacle RC1

RC1 supplies 60 Hz single-phase power at weld/power speed. Maximum output is 4

kVA/kW.

2120 V 20 A AC Duplex Receptacle RC2

RC2 supplies 60 Hz single-phase power at weld/power speed. Maximum output from RC2 is 2.4 kVA/kW.

3 Circuit Breaker CB1

CB1 protects the receptacles from over- load. If CB1 opens, the receptacles do not work.

210 586

.Place switch in the On position to reset

circuit breaker. If breaker continues to open, contact Factory Authorized Ser- vice Agent.

Combined output of all receptacles limited to 4 kVA/kW rating of the generator (See Section 10 – Generator Power Guide- lines).

EXAMPLE: If 15 A is drawn from the 120 volt duplex receptacle, only 9 A is available from the 240 V duplex receptacle.

(120 V x 15 A) + (240 V x 9 A) = 4 kVA/KW.

OM-4418 Page 17