ASSEMBLING THE OVEN TO THE STAND
FRONT OF TOP OVEN
Unpack the oven and stand. Position oven on its back, taking care not to scratch or damage it.
Install the two locating studs (included in the stand carton) into the screw plates on the underside of the oven ( Fig. 2).
Attach each of the four leg assemblies to the bottom of the stand with the 24 bolts and lockwashers (6 per leg).
Mount the oven on top of the stand.
Adjust the legs to ensure that the oven racks are level in the final installed position.
ELECTRICAL CONNECTIONS
LOCATING STUDS
BOTTOM
KNOCK OUT WELDED PLATE FOR FLUE EXTENSION INSTALLATION
REAR OF TOP OVEN
Fig. 2
WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE APPLICABLE PORTIONS OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL ELECTRICAL CODES.
WARNING: DISCONNECT THE ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE DISCONNECT SWITCH INDICATING THAT YOU ARE WORKING ON THE CIRCUIT.
ELECTRICAL DATA
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| NOMINAL AMPS PER LINE WIRE |
| ||||||||
|
| TOTAL |
|
|
|
| 3 PHASE |
|
| 1 PHASE | |||||
|
| (KW PER PHASE) |
|
|
|
|
|
| |||||||
|
| KW |
|
| 208V. |
|
|
| 240V. |
| 208V. | 240V. | |||
|
|
|
|
|
|
|
|
|
|
| |||||
|
|
| L1 | L2 |
| L3 | L1 | L2 | L3 | ||||||
|
|
|
|
|
| ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Single Oven | 5.5 | 2.5 | 0 | 3.0 |
| 23.0 | 10.0 |
| 12.0 | 20.0 | 9.0 | 11.0 | 26.0 | 23.0 |
| Stacked Ovens | 11.0 | 5.0 | 0 | 6.0 |
| 46.0 | 20.0 |
| 24.0 | 40.0 | 18.0 | 22.0 | 52.0 | 46.0 |
Knockouts are provided on the back and bottom of the oven for making conduit connections. Remove the screws from the front control panel for access to the terminal block.
Wire and required hardware for making connections between stacked ovens are furnished with the leg stack set.
Replace the right side panel if it was removed during electrical connection.
Replace the front control panel and turn on the power supply.
– 5 –
