Hobart HEC5D ML-126751 Assembling The Stand To The Oven, Electrical Connections, Electrical Data

ASSEMBLING THE STAND TO THE OVEN

Attach each of the four leg assemblies to the bottom of the oven with the 24 bolts and lockwashers (six per leg). Carefully raise the oven to the normal position.

Attach the undershelf to the legs with eight bolts and lockwashers (two per leg).

Install the rack guides into the shelf at the desired locations (for pan or flat rack), then attach the rack supports to the top end of the rack guides. Attach rack supports to the leg assembly by removing one middle bolt and reattaching the back through the end holes in the rack support (Fig. 2).

BACK

FRONT

PL-53274

Fig. 2

ELECTRICAL CONNECTIONS

WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE APPLICABLE PORTIONS OF THE NATIONAL ELECTRICAL CODE ANSI/NFPA70 (LATEST EDITION) AND/OR OTHER LOCAL ELECTRICAL CODES.

WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE DISCONNECT SWITCH TO INDICATE THAT YOU ARE WORKING ON THE CIRCUIT.

Remove the wiring compartment cover on the front of the oven. Remove the appropriate knockout on the bottom of the oven and attach the power supply conduit to the bottom of the oven.

Comply with the wiring diagram (located inside the right side panel) when making connections to the electrical supply lines.

Replace the wiring compartment cover and right side panel. Turn on the power supply.

ELECTRICAL DATA

			208-240 V					480 V					NOMINAL AMPERES PER LINE WIRE
	TOTAL	3-PHASE LOADING					3-PHASE LOADING							3-PHASE					1-PHASE
	KW	KW PER PHASE					KW PER PHASE				208 V			240 V			480 V		208 V	240 V	480 V
		L1-L2		L2-L3	L1-L3		L1-L2	L2-L3	L1-L3	L1	L2	L3	L1	L2	L3	L1	L2	L3
Single Oven	12.5	4		4		4.5	4	4	4.5	35	33	35	33	29	33	14.4	15.3	15.3	60	52		26
Stacked Oven	25	8		8		9	8	8	9	70	66	70	66	58	66	28.8	30.6	30.6	120	104		52

– 5 –