Bowl Guard (Fig. 4)
The Wire Cage Assembly on the Bowl Guard can be rotated
To Rotate the Wire Cage Assembly to the Rear
Push the Latch in to release the Centering Pin from the Centering Ramp. Note how the grooves on the nylon Retainers allow the Wire Cage to ride around the circular Ridge of the planetary Drip Cup. The Wire Cage can rotate 360° to the left or right. When the Wire Cage returns to the front and center position, the Centering Pin is captured and held by the Centering Ramp, restricting rotation of the Wire Cage until the Latch is pressed again.
The Wire Cage must be in the
To Remove the Wire Cage Assembly for Cleaning
Lower the Bowl. Rotate the Wire Cage to the rear. Remove both Agitator and Bowl. Return the Wire Cage to the front.
While holding the Wire Cage securely with both hands, use your thumb to push down on the Black Release Knob. Lower and remove the Wire Cage. Wash it in a sink or dishwasher, rinse with clear water, and dry with a clean cloth.
The stainless steel Splash Guard can be wiped off or washed easily with a cloth or sponge and warm soapy water. Rinse with clear water. Dry with a clean cloth.
To Reinstall the Wire Cage Assembly
Hold the Wire Cage so its top ring is positioned around the planetary Drip Cup with the grooves in both nylon Rear Retainers straddling the Ridge on the Drip Cup. Push in the
Rotate the Wire Cage
Return the Wire Cage to its front and center position to operate the mixer.
Wire Cage Rotated Left | Latch | Ridge On Drip Cup |
|
|
Rear Retainer
Splash Guard
|
|
Centering Ramp | Retainer |
Wire Cage Front-Center Position
Centering Pin
Black Release Knob
Fig. 4
– 11 –