Hobart M802, V1401 PROGRAMMABLE TIMER CONTROLLER when equipped, For Continuous Mixing, Timer Keys

PROGRAMMABLE TIMER CONTROLLER (when equipped)

At Idle, the timer display [ – – : – – ] shows that no time has been set (Fig. 3).

				Time Display				Power Bowl Lift Lever
								Pilot Light
			P1 Key
								Stop Button
Clutch	P2 Key
								Start Button
Oil Level Gauge
Gear Shift Lever							Save Key
		M/C Indicator
	Clear Key
					Knob

Fig. 3

PL-40070-1

Timer Keys	Programming Function (if the mixer is not mixing).
P1	Contains up to four preset times. Displays each preset time sequentially.
P2	Contains up to four additional preset times. Displays each preset time sequentially.
Knob	Changes the time as indicated by the display.
Save	Replaces the preset time with the indicated time.
Clear	Returns to Idle from a programming function.

For Continuous Mixing

START and STOP buttons control mixing operation.

Beginning from the Idle display [ – – : – – ], press START to begin mixing. The M/C indicator will be lit and the total mixing time will be indicated (minutes and seconds).

Press STOP when mixing is done; the M/C indicator light goes off; and the Idle display [ – – : – – ] returns.

Using the Dial Timer to Set the Mixing Time

Beginning from the Idle display [ – – : – – ], turn the KNOB to set the mixing time. The M/C indicator will be lit.

START and STOP buttons control mixing operation.

Press START to begin mixing. The timer will count down from the set time to [ 00 : 00 ].

If STOP is pressed, both mixing and timer countdown will be interrupted. After pressing STOP, press START to resume both mixing and timer countdown, or press CLEAR to return to the Idle display.

When the timer reaches [ 00 : 00 ], the mixer stops; the M/C indicator goes off, a beep

tone sounds for two seconds, and the Idle display [ – – : – – ] returns.

– 7 –