Fig. 5
9.Install one
Fig. 8
12.Install the brass adapters into the in/out ports and secure by reinstalling the bracket and pin.
Fig. 6 | Fig. 9 |
10.Apply a small amount of seal lube evenly onto each
Fig. 7
11.Remove the pin and bracket from the softener in/ out port area.
13.The female end of the connector hoses is designed to thread onto 3/4" pipe thread. Perform appropriate plumbing to provide connections from the water supply to the inlet hose/port and from the outlet port/hose.
NOTE: The inlet port is identified with an arrow pointing towards the softener controls. The outlet port is identified with an arrow pointing away from the softener controls. These connections may be made before the pressure reducing valve.
14.Insert tubing provided into the drain port on the back of the cabinet and run it to an appropriate drain. Be sure to provide a “air gap” between the end of the tubing and the top of the drain.
NOTE: Drain line length should not exceed 8 feet vertical and 30 feet horizontal from the softener.
F25404 Rev. A (0413) |
| Page 4 of 10 |
|