5-6. Removing Gun From Welding Power Source
Y Turn off welding power source.
Head
Tube
8 mm
Remove nozzle. Cut off wire | Open pressure assembly. Retract | . Hold wire tightly to keep it | ||
at contact tip, and remove | wire from liner onto spool. | from unraveling. Secure | ||
contact tip and tip adapter. |
| |||
| end of wire at spool. | |||
|
| |||
|
|
|
|
|
|
|
|
|
|
Disconnect weld cable from weld terminal.
Remove wrapper from | Remove screws (3) from |
unit. | cover, and remove cover |
| from wire drive assembly. |
Disconnect trigger leads from
RC3 and RC4 on PC1.
Pull weld cable through opening in baffle.
Disconnect gas hose from adapter (if unit is not equipped with gas solenoid valve, loosen hose from wiring harness).
Remove leads and hose from cable tie(s).
Pull weld cable, trigger leads, and gas hose through opening in drive housing. Pull gun cable out through opening in front panel. To reinstall gun see Section
803
