Hobart Welding Products OM-2208 Meter Functions For CC Model, Mode Switch Settings For CC Model

4-5. Meter Functions For CC Model

NOTE

The meters display the actual weld output values for approximately three seconds after the arc is broken.

Mode		Meter Reading At Idle			Meter Reading While Welding
		V		A	V		A
Scratch		80.0		85	10.3		85
Start TIG
	Actual Volts (OCV)		Preset Amps		Actual Volts	Actual Amps
		V		A	V		A
Lift-Arc TIG		7.0		85	10.3		85
		Actual Volts	Preset Amps		Actual Volts	Actual Amps
		V		A	V		A
TIG				85	10.3		85
		Blank	Preset Amps		Actual Volts	Actual Amps
		V		A	V		A
Stick		80.0		85	24.5		85
(Stiff Or Soft)
	Actual Volts (OCV)		Preset Amps		Actual Volts	Actual Amps

4-6. Mode Switch Settings For CC Model

NOTE

The Stick modes provide the Adaptive Hot Start feature, which automatically increases the output amperage at the start of a weld should the start require it. This eliminates electrode sticking at arc start.

Mode Switch Setting	Process	Output On/Off Control
Scratch Start TIG	GTAW	Electrode Hot
Lift-Arc TIG	GTAW With Lift-Arc Start – See Section 4-7	Electrode Hot
TIG	GTAW With HF Unit, Pulsing Device, Or Remote Control	At Remote 14
Stick (Stiff)	SMAW When A Stiff Arc Characteristic Is Desired	Electrode Hot
Stick (Soft)	SMAW When A Soft Arc Characteristic Is Desired	Electrode Hot

OM-2208 Page 19