A SS E M B LY
I N S T R U C T I O N S
Step 2f
F R A M E A S S E M B L Y
In this step start by pressing the two Guide Rod Bushings into the Weight Cage. Take the two Weight Bumpers and place them over the two holes in the bottom of the Weight Cage. Now slide the Guide Rods into the holes. Make sure the Guide Rods are lube with Spindle Oil. Now, slide (20) 20 LBS. Intermediate Weight Plates and the (1) 41 LBS. Steel Top Plate onto the Guide Rods. Make sure the Weight Stack and its Guide Rods are sitting level. Next attach the Add On Rod to the Center RH (BRK) Assembly. Secure the Center RH (BRK) Assembly to the 41 LBS. SteelTop Plate, slide on the three Add On Weights and attach another Add On Rod to the Weight Cage. Attach bigger end of the Selector Pin Lanyard to the Center RH (BRK) Assembly, and the other end to the Weight Selector Pin. Then Wrench tighten bolts.
Part Descriptions | Hardware Descriptions | |
33 | - Center RH (BRK) Assembly | K - |
34 | - Add On Rods | L - |
35 | - Add On Weights | M - |
36 | - Weight Selector Pin | N - |
37 | - Guide Rods | AG - 3/8” Lock Washer (White Zinc) |
38 | - Weight Bumpers | AH - 3/8” Flat Washer (White Zinc) |
39 | - Guide Rod Bushings | AJ - 3/8” Lock Washer (Black Zinc) |
40 | - 41 lbs. Steel Top Weight | AK - 3/8” Flat Washer (Black Zinc) |
41 | - 20 lbs. Intermediate Weight | AL - 5/16” Lock Washer (Black Zinc) |
64 | - Add On Weight Bushing | AM - 5/16 Flat Washer (Black Zinc) |
|
| AN - 3/8” Split Washer (White Zinc) |
|
| CK - Selector Pin Lanyard |
|
| CM - Top Weight Roll Pin |
|
| CN - Guide Bearing (Tall) |
|
| CP - Guide Bearing (Short) |
Page 15
HOIST
FITNESS SYSTEMS
R
2403 Assembly
