A SS E M B LY
I N S T R U C T I O N S
Step 2g
F R A M E A S S E M B L Y
In this step start by attaching the Belt Assembly to the Weight Assembly (prior to attaching the Cam Belt). Place smooth side of Cam Belt on the Pulley and Cam. Next slide the Cam Belt through the Pulley Bracket on the top of the Weight Cage. Then use a Seat Clamp On tool to secure the two 3 1/4” Pulleys to the Weight Cage under the Cam Belt. Slide the Cam Belt into the top slot of the 1 5/8”x 2 1/16” LG. Tube (Fig. 1). Loop the end of the Cam Belt and feed it back up through the slot, keeping the loop open (Fig. 2). Next slide the Belt Retainer Shaft through the Cam Belt and line up the holes, then secure to the 1 5/8” x 2 1/16” LG. Tube (Fig. 3). Next attach the Cam Belt by bringing it down and through the pulley bracket behind the 3 1/4” Pulley. Now bring the Cam Belt around the Large Cam Assembly and in between the Serrated Clamps. Then wrap the Cam Belt down and around the Serrated Clamp and above another Serrated Clamp and secure all of the Serrated Clamps together. Next wrap the short cam belt on the Small Cam Assembly as shown. Wrench tighten bolts.
Part Descriptions | Hardware Descriptions | |
42 | - Cam Belt (110” LG.) | P - |
| ||
44 | - Cam Belt (42” LG.) | Q - |
| ||
45 | - Serrated Clamps | R - |
| ||
46 | - Belt Retainer Shaft | AG - 3/8” Lock Washer (White Zinc) |
| ||
47 | - Tube (1 5/8” x 2 1/16” LG.) | AH - 3/8 Flat Washer (White Zinc) |
| ||
AP - 1/4” Lock Washer (Black Zinc)
BC - 3/8” Lock Nut (Black Zinc)
BD - 1/4” Lock Nut (White Zinc)
CL - 3 1/4” Pulley
Page 17
HOIST
FITNESS SYSTEMS
R
2403 Assembly
