Hoist Fitness CL-2403 owner manual Including all previously hand tightened bolts

A SS E M B LY

I N S T R U C T I O N S

Step 2i

F R A M E A S S E M B L Y

In this step start by pressing two 1” O.D. X 3/4” I.D. Flanged Oilites into the Seated Frame Assembly. Attach the Range Adjuster Plate to the Back Adjuster Seated Assembly. Next insert the 3/4” x 4 27/32” Shaft into the Seated Frame Assembly. Make sure the 1/8” hole on the Shaft is in line with the 3/16” hole on the Seated Frame Assembly. Then insert any small metal pin to secure the Shaft for bolt alignment. Now remove the small metal pin when finish bolting.. Next attach the Back Adjuster Seated Assembly to the Seated Frame Assembly as shown. For the final step, attach the 0.125” x 1.50” x 1.79” Plate to the end of the Back Adjuster Seated Assembly as shown. Then Wrench tighten bolts

including all previously hand tightened bolts.

Part Descriptions		Hardware Descriptions
14	- Pull Pin	E - 3/8”-16 x 3/4” Flat Head Screw (White Zinc)
17	- Back Adjuster Seated Assembly	F - 3/8”-16 x 1 1/2” Flat Head Screw (White Zinc)
18	- 0.125” x 1.50” x 1.79” Plate	U - 1/4”-20 x 3/4” Button Head Screw (White Zinc)
19	- Range Adjuster Plate	AR - 1/4” Lock Washer (White Zinc)
20	- 3/4” x 4 27/32” Shaft	AS - 1/4” Flat Washer (white Zinc)
		CE - 1” O.D. X 3/4” I.D. Flanged Oilite

Page 21

HOIST

FITNESS SYSTEMS

R

2403 Assembly