ASSEMBLY INSTRUCTIONS CONTINUED
Fan Head Assembly
NOTE: Remove the plastic piece covering the motor shaft and discard. Also remove the plastic covering the logo plate.
Step 1: Position the rear grill over the motor shaft, making certain the 3 holes at the top and bottom of the rear grill fit over the
3 prongs on the motor housing. Please make sure the rear grill fits securely against the motor housing.
Step 2: Secure the rear grill in its place using the rear grill
Step 3: Slide the fan blade; with the hollowed interior of the blade facing towards the rear grill firmly onto the motor shaft. Make sure the shaft protrudes from the front of the blade.
Step 4: Secure the fan blade onto the motor shaft by turning the blade cap in a
Step 5: Center the front grill by aligning the Holmes logo so it is horizontal and parallel to the floor. Then secure the front and rear grills completely together by placing the front grill onto the back grill making sure the Holmes logo is straight. Then close and lock the clips into place around both grills.
Final Assembly
Step 1: Place and slide the upper pole and fan head assembly onto one of the extension poles. Then, simply insert the fan post screw into the hole and tighten until a secure fit is obtained.
OPERATING INSTRUCTIONS
Step 1: Set the fan base on a dry, level surface.
Step 2: Please make sure the On/Speed knob is in the "O" Off position. Plug the cord into any standard
Step 3: The SPEED is adjusted by moving the knob left or right to the desired setting.
Step 4: The OSCILLATION control knob is located on the top of the fan motor housing. To start oscillation, push control knob down. To stop oscillation, pull control knob up.
ADJUSTMENT INSTRUCTIONS
Tilt Adjustment
To change the tilting angle of the fan head, move the fan head to the desired angle.
Height Adjustment
(See instructions for base/pole assembly)
This fan is equipped with two extension poles, which allow you to adjust the height of the fan for two height settings.
CLEANING/MAINTENANCE
Follow these instructions to correctly and safely care for your Holmes stand fan. Please remember:
•Always unplug the fan before cleaning or disassembling.
•Do not allow water to drip on or into the fan motor housing.
•Do not use any of the following as a cleaner: gasoline, thinner, benzine
(See instructions for fan head assembly)
Step 1: To access the fan blade, remove the front grill and the fan blade nut.
Step 2: Clean the fan blade, both front and rear grills with a soft cloth moistened with a mild soap solution.
Step 3: Replace blade, tighten the fan blade nut, and securely fasten the front grill.
Fan Head, Base, and Pole Cleaning
Using a soft, moist cloth, with or without a mild soap solution, carefully clean the fan base, pole, and head. Please use caution around the motor housing area. Do not allow the motor or other electrical components to be exposed to water.
