Holmes HASF1750RC16 Fan Head Assembly, Remote Control Handheld Unit, Final Assembly

Fan Head Assembly

Step 1: Position the rear grill over the motor shaft, making certain the 2 notches at the top and bottom of the rear grill fit over the 2 protruding notches on the motor housing. Please make sure the rear grill fits securely against the motor housing.

Step 2: Fasten the rear grill in place using the rear grill mounting-ring. Turn the ring clockwise and tighten firmly.

Step 3: Slide the fan blade; with the hollowed interior of the fan blade facing toward the rear grill firmly onto the motor shaft. Make sure that the motor shaft protrudes from the front of the blade.

Step 4: Secure the fan blade onto the motor shaft by turning the fan blade cap counter-clockwise. Tighten until secure.

Step 5: Snap the logo plate on to the front grill, making sure the clips on the logo plate, fit into the open- ings on the front grill.

Step 6: On the front grill, lift the grill clips up so that there is no interference when placing the front grill onto the rear grill. Center the front grill, aligning the Holmes logo so it is horizontal and parallel to the floor. Hang the front grill onto the rear grill and close all of the clips until the two grills are secured.

Final Assembly

Step 1: Place the hollow end of the remote control hous- ing on to the upper pole until it will not go down any further.

Step 2: Tighten the locking nut on the back of the remote control housing by turning it clockwise until the fan head assembly is secure.

Remote Control Handheld Unit:

Your remote control requires 2 AAA batteries for operation. To install the batteries, simply depress the back of the remote with your thumb on the spot marked OPEN. Insert bat- teries according to the diagram shown inside. Replace cover.

•Do not mix old and new batteries.

•Do not mix alkaline, standard (carbon-zine), or rechargeable (nickel-cadmium) batteries.