USER MANUAL
ENGLISH
SIDE BROOM HEIGHT CHECK AND ADJUSTMENT
1.Check that the side broom is at the correct height from the ground, according to the following procedure:
•Drive the machine on a level ground and lower the side broom.
•Keep the machine stationary and turn on the side broom for a few seconds.
•Turn off the side broom by pressing the switch (1), then lift it and move the machine.
•Check if the size and orientation of the print left by the side broom are as shown in the fi gure (A, Fig. 1): the side broom must touch the ground along a circle arc ranging from "11 o'clock" position to "3 o'clock" position.
•If the print is not within specifi cations, it is necessary to adjust the broom height, according to the procedure shown in step 2.
2.Turn the knob (13) clockwise and
3.Perform step 1 again to check that the side broom is at the correct height from the ground.
4.When the broom is too worn and can no longer be adjusted, replace it according to the procedure shown in the following paragraph.
11
Figure 1
3
S311350
SIDE BROOM DISASSEMBLY/ASSEMBLY
CAUTION!
It is advisable to use protective gloves when
replacing the side broom because there can be BC sharp debris between the bristles.
1.Drive the machine on a level ground.
2.Turn the main switch (1) to “0”.
3. Lift the side broom.
4. Loosen the knob (A, Fig. 2) inside the side broom, then remove the broom (B) by disengaging it from the pins
(C).
5. Install the new broom on the machine engaging it on the pins (C), then tighten the knob (A).
6.Adjust the height of the new broom according to the procedure shown in the previous paragraph.
A
S311351
Figure 2
SW 750
146 3080
13
