Manuals / Coleman / Outdoor Cooking / Gas Grill

Coleman 9947A726 BURNER ASSEMBLY cont, Hose Routing, Grease Pan & Grease Tray, Warming Rack, Step

Models: 9947A726

1 20

Download 20 pages 48.47 Kb

Page 10

STEP 9 BURNER ASSEMBLY (cont.)

Assembly/Set up (cont.)

STEP 9 BURNER ASSEMBLY (cont.)

■The cardboard packing below the burners cannot be easily removed. It will burn away during the first use.

STEP 10 HOSE ROUTING

STEP 11

GREASE PAN & GREASE TRAY

■Note: Remove Grease Tray

and packing from rear of grill.	Grease Tray
(This is the storage position of
the Grease Tray for shipping.)

■Grease Pan attaches to Grease Tray with slides.

■Install Grease Pan as shown.

Grease Pan

■Slide Grease Tray into Grill.

■Route Burner Valve at end of Hose through hole in cart end.

■Insert Orifice Tube into burner, then rotate valve until valve stem goes through hole in side table top.

NOTE: Valve must be inserted into Burner Inlet.

Burner Valve Stem

Orifice

Tube

STEP 12 BURNER TENTS & GRATES

■Place Burner Heat TentsTM over Burners as shown.

■Align screw holes of Valve Bracket with holes in brace.

■Install screws and tighten.

2Required

■Install Valve Knob on Valve Stem.

10

■Install three (3) Grates.

STEP 13 WARMING RACK

■Install Warming Rack as shown.

Image 10

Coleman 9947A726 BURNER ASSEMBLY cont, Hose Routing, Grease Pan & Grease Tray, Burner Tents & Grates, Warming Rack, Step

Contents

or TDD 316-832-8707. In Canada call Leave these instructions with the consumerRead all instructions and keep in a safe place for future reference Use, Care & Assembly ManualDANGER ContentsGeneral Safety Information IF YOU SMELL GASGeneral Installation General Safety Information contNatural Gas Connections Electrical AttachmentsLP Fuel Connections Other Than Portable L.P. Cylinders Portable L.P. Gas Barbecue CylindersHose and Regulator Cylinder SpecificationsPortable L.P. Gas Barbecue Cylinders cont Transporting the CylinderFilling and Purging Type L.P. Gas Cylinders cont Transporting the Cylinder contFilling and Purging Type L.P. Gas Cylinders Take these instructions to the L.P. gas dealerAssembly/Set up STEP 2 CASTERS Assembly/Set up contSTEP 1 BOTTOM & SIDE PANELS STEP 3 MIDDLE DIVIDERSTEP 7 RIGHT SIDE TABLE STEP 6 INSTALLING IGNITION BOXSTEP 9 BURNER ASSEMBLY STEP 8 LEFT SIDE BURNERGREASE PAN & GREASE TRAY STEP 9 BURNER ASSEMBLY contSTEP 10 HOSE ROUTING STEP 12 BURNER TENTS & GRATESSTEP 16 LOWER DOOR MAGNETS STEP 18 DOORSSTEP 19 DOOR HANDLES STEP 17 UPPER DOOR MAGNETSSTEP 21 PROPANE CYLINDER SETUP Connecting Type 1 L.P. Gas CylindersLeak Testing STEP 22 INSTALLING IGNITION BOXFixing A Fuel Leak Leak Testing contHow to Check for Leaks Start-Up Check ListLighting Main Burners cont Lighting Instructions contLighting Main Burners Lighting Side BurnerGeneral Use and Correct Burner Flames Burner Control Setting TipsShutting Off the Grill cont Grilling Tips and HintsCleaning and Maintenance Cleaning the VenturiCleaning the Venturi cont Steps For Cleaning VenturiProblem Burner will not light or has incom- plete burner flame Cleaning and Maintenance contTroubleshooting Problem Yellow flameFor Your Additional Safety cont Troubleshooting contFor Your Additional Safety Problem Flame behind control panel or control knob areaDescription Replacement Parts ListDescription FOR 6000 SERIES GRILLS WarrantyCOLEMAN GAS BARBECUE GRILL LIMITED WARRANTY