Assembly/Set up (cont.)
STEP 1 BOTTOM & SIDE PANELS
■Install three screws from the top and three Hex nuts from below as shown for each side panel.
■Tighten screws.
Panel with hole | 6 Required | |
must be installed | ||
as shown. |
| |
|
|
|
|
|
|
|
|
|
STEP 2 CASTERS
■Carefully turn over assembly.
■Install Casters by threading them into position as shown.
NOTE: The Casters with locking arms attach to the front of the assembly. Tank caddy location is on left when assembly is viewed from front.
Locking Arm
Front of Assembly
STEP 3 MIDDLE DIVIDER
■Turn over assembly so wheels are down.
■Install Middle Divider as shown.
2 Required
NOTE: The tall side of the middle divider should be on the front side of the grill.
STEP 4
TOP PANEL
6Required
■Set Top Panel into position on top of Middle Divider.
■Align holes and hand- install 2 screws.
■Install screws where Top Panel joins to Sides.
■Tighten screws.
STEP 5 BACK PANEL
■Install Back Panel as shown.
NOTE: Top & bottom row of screw holes have weld nuts. No nuts are required for these screws.
Back of Assembly
■Tighten ALL screws previously
now complete. Only Front Casters have locks to
secure unit.
6 Required
8
Front of Assembly
