Home Automation 10A11-1 manual Mounting, Speaker/Microphone Connections, Page

28A00-1, 28A00-2,

33A00-4 CONSOLE,

33A00-20 KEYPAD, OR

SPEAKERS / MICROPHONES

8 OHM	TWISTED PAIR
SPEAKER

MODEL 10A11-1, REV C

TWO-WAY AUDIO/VOICE ALARM MODULE

+ SPKR1	(SPEAKER #1 OUTPUT)
- SPKR1	(SPEAKER #1 COMMON)
+ SPKR2	(SPEAKER #2 OUTPUT)
- SPKR2	(SPEAKER #2 COMMON)

8 OHM

TWISTED PAIR

SPEAKER

TWO-WIRE

ELECTRET

MICROPHONE

TWO-WIRE

ELECTRET

MICROPHONE

AUDIO IN

SOURCE 6

HI-FI

PAGE

IN

HI-FI

TWISTED PAIR WITH SHIELD

+

_

+

_

+ MIC1	(MICROPHONE #1 INPUT)
- MIC1	(MICROPHONE #1 COMMON)
+ MIC2	(MICROPHONE #2 INPUT)
- MIC2	(MICROPHONE #2 COMMON)

LINE OUT (LINE-LEVEL AUDIO OUTPUT)

PAGE OUT (PAGE OUTPUT)

PAGE OUT (PAGE OUTPUT)

Figure 1 - Speaker/Microphone Connections

MOUNTING

When mounting and connecting the Model 10A11-1, Rev C, power down the controller (AC and battery). Connecting the Model 10A11-1, Rev C board, while power is still applied to the controller, can damage the board, the controller, or both.

Mount the Model 10A11-1, Rev C to the upper right side of the enclosure using the supplied adhesive-backed resealable fasteners.

When connecting to an OmniLT, route the cable to the connector on the top of the board marked "J1". Plug the Model 10A11-1, Rev C cable into "J1" on the controller. The red wire should be to the left of the connector (red wire to Pin 1) - See Figure 2. Make sure that the connector is aligned with the pins on "J1".

When connecting to an Omni II, OmniPro II, Lumina, or Lumina Pro, route the cable along the top of the enclosure to the connector on the left side marked "J2". Plug the Model 10A11-1, Rev C cable into "J2" on the controller. The red wire should be to the top of the connector - See Figure 3. Make sure that the connector is aligned with the pins on "J2".

Page 2