With a PC

Setup

2 Connecting to a PC

 

Connect this unit to the PC after the software applications are installed.

Remove the supplied CD-ROM from your PC.

AUSB cable (supplied)

1 Connect this unit to the AC adaptor.

It is possible to use the unit connected to the PC with the batteries only, but you will not be able to write data into the unit.

Connect with the AC adaptor when using the Conversion Assist Function.

2 Turn on the unit.

This function is available in all modes.

3 Connect this unit to a PC.

The USB function selection screen will appear.

4 Touch [PC] on the screen of this unit.

The Smart wizard screen is automatically displayed when HD Writer AE 2.6X is installed.

This unit is automatically recognized as an external drive of the PC. (l 112)

When you select an option other than [PC], reconnect the USB cable.

When using the battery, the LCD monitor turns off after about 5 seconds. Touch the screen to turn the LCD monitor on.

Do not use any other USB cables except the supplied one. (Operation is not guaranteed with any other USB cables.)

When the unit is connected to a PC, it cannot be turned off. Disconnect the USB cable, before turning this unit off.

Do not disconnect the USB cable or the AC adaptor while the access lamp is on or card access icon ( ) appears on the unit screen.

When performing reading/writing between a PC and an SD card, be aware that some SD card slots built into PCs and some SD card readers are not compatible with the SDHC Memory Card or SDXC Memory Card.

When using an SDXC Memory Card, check the following support site. http://panasonic.net/avc/sdcard/information/SDXC.html

110

VQT2W55

Page 110
Image 110
Panasonic HDC-SDX1P operating instructions Connecting to a PC