HoMedics SPS-060 manual Troubleshooting, Specifications

TROUBLESHOOTING

If any abnormality arises during use, please check the following points

SYMPTOMS	POSSIBLE	CORRECTION
	CAUSES
Unit does not turn	Batteries have	Replace them with
on when the START/	run down.	two new AA alkaline
STOP		batteries.
button is pushed.
	Battery polarities	Re-insert the batteries
	have been positioned	in the correct
	incorrectly.	positions.
EE measurement	Cuff has been placed	Wrap the cuff properly
error symbol shown	incorrectly.	so that it is positioned
on display or the		correctly.
blood pressure
	Did you talk or move	Measure again.
value is displayed	during measurement?	Keep arm steady
excessively low		during measurement.
	Shaking of the arm
(or high).	with the cuff on.
E1 error symbol	Air circuit abnormality.	Check cuff connection.
shown on display	Cuff tube may not be	Measure again.
	plugged into monitor
	correctly.
E2 error symbol	Inflation pressure	Turn the unit off, then
shown on display	exceeding 300 mmHg.	measure again.
E3 error symbol	Error determining	Measure again.
shown on display	measurement data.

Note: If the unit still does not work, contact HoMedics Consumer Relations. Under no circumstance should you disassemble or attempt to repair the unit by yourself. Contact information for HoMedics Consumer Relations Department can be found on the warranty page.

27

BPS-060_B.indd 29-30

SPECIFICATIONS

Power Source:	Four 1.5V DC (AA) batteries
Measurement	Oscillometric
Method:
Measurement Range:	Pressure: 40~280 millimeters mercury (mmHg)
	Pulse: 40~199 beats/minute
Accuracy:	Pressure: ±3 mmHg
	Pulse: ±5% of reading
Pressure Sensor:	Semi-conductor
Inflation:	Manual Inflation
Deflation:	Automatic Pressure release valve
Memory Capacity:	60 memories
Auto-shut-off:	1 minute after last button operation
Operation	Temperature: 50°F~104°F (10°C ~40°C)
Environment:	Humidity: 15% – 90% R.H.
Storage Environment:	Temperature: -4°F~158°F (-20°C~70°C)
	Humidity: Less than 90% R.H.
Weight:	.43 lbs/193 grams (without batteries)
Arm Circumference:	Standard size adult arm cuff:
	9”–13” (23 – 33 cm)
Dimensions:	5”(L) x 4.1”(W) x 2.7”(H)
	126mm(L) x 105mm(W) x 68mm(H)
	Internally Powered equipment
	Type BF Equipment
	IPx0-No special protection against the
	ingress of water
	Not suitable for use in presence of flammable
	anesthetic mixture with air, oxygen or
	nitrous oxide.
	Continuous operation with short-time loading.

Note: These specifications are subject to change without notice.

28

5/01/10 1:27 PM