assembly
WARNING:
Do not attempt to operate the generator until assembly is complete. Failure to comply could result in possible serious personal injury.
LOOSE PARTS LIST
See Figure 2.
The following items are included with the generator:
Key |
|
|
No. | Description | Qty. |
1 | Wheel | 2 |
2 | Spacers | 4 |
3 | Bolts | 2 |
4 | Axles | 2 |
5 | Lock Nuts | 2 |
6 | Bottle of Engine Lubricant | 1 |
7 | Pins | 2 |
8 | Lock nuts | 6 |
9 | Feet | 2 |
10 | Handles | 2 |
11 | Spark plug wrench (not shown) | 1 |
| Operator’s Manual (not shown) | 1 |
TOOLS NEEDED
See Figure 3.
The following tools (not included or drawn to scale) are needed for assembly:
Utility Knife
13 mm Socket Wrench
11 mm and 17 mm Box End Wrench
NOTE: Do not put fuel or lubricant in the generator before installing the legs and wheels.
UNPACKING
This product requires assembly.
Carefully cut the box down the sides then remove the machine and any accessories from the box. Make sure that all items listed in the packing list are included.
NOTE: This machine is heavy and requires a minimum of two people to lift. To avoid back injury, lift with your legs and not your back.
Inspect the unit carefully to make sure no damage oc- curred during shipping.
Do not discard the packing material until you have carefully inspected and satisfactorily operated the product.
If any parts are damaged or missing, please call
WARNING:
If any parts are damaged or missing do not operate this product until the parts are replaced. Use of this product with damaged or missing parts could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create acces- sories not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious per- sonal injury.
WARNING:
Do not attempt to operate the generator until assembly is complete. Failure to comply could result in possible serious personal injury.
NOTE: Do not put fuel or lubricant in the generator before installing the feet and wheels.
installing feet
See Figure 4.
Raise the end of the generator where the recoil starter is located high enough to gain access to the frame bottom; securely position props underneath to support.
Locate the following items:
2 foot/leg assemblies
4 lock nuts
Insert bolts for a foot/leg assembly through the holes on one side of the frame as shown.
Install nuts and tighten securely.
Repeat with remaining foot.
WARNING:
Do not use this product if any parts on the Loose Parts List are already assembled to your product when you unpack it. Parts on this list are not assembled to the product by the manufacturer and require customer instal- lation. Use of a product that may have been improperly assembled could result in serious personal injury.
installing the wheels
See Figure 5.
Wheels are provided to assist in moving the generator to the desired location and should be installed on the side opposite the recoil starter.
Locate the following items: 2 axles
2 wheels
2 lock nuts
2 pins
Page 11 — English
