ASSEMBLY
UNPACKING
This product requires assembly.
Carefully cut the box down the sides then remove the |
machine and any accessories from the box. Make sure |
that all items listed in the packing list are included. |
NOTE: This machine is heavy and requires a minimum of |
two people to lift. To avoid back injury, lift with your legs |
bolt
nut washer
and not your back. |
Inspect the unit carefully to make sure no damage oc- |
curred during shipping. |
Do not discard the packing material until you have carefully |
inspected and satisfactorily operated the product. |
If any parts are damaged or missing, please call |
WARNING:
If any parts are damaged or missing do not operate this product until the parts are replaced. Failure to heed this warning could result in serious personal injury.
frame washer
frame support
WITH FOOT
flange nut
rubber
foot
bolt
Fig. 2
WARNING:
Do not attempt to modify this product or create acces- sories not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious per- sonal injury.
WARNING:
Do not attempt to operate the generator until assembly is complete. Failure to comply could result in possible serious personal injury.
NOTE: Do not put fuel or lubricant in the generator before installing the feet, frame support, and wheels.
installing feet on the frame support
See Figure 2.
Locate the following items:
2 rubber feet
2 lock nuts
2 washers (1/4 in.)
2 bolts
Insert bolt through foot, then through frame support as shown.
Slide a washer on the bolt, then install nut. Tighten nut securely.
NOTE: Be careful not to overtighten so that foot mate- rial collapses.
Repeat with remaining foot.
installing the frame support
See Figure 2.
Install the frame support on the bottom of the generator frame on the same side as the handle.
Locate the following items: Frame support
2 flange nuts
2 washers (5/16 in.)
2 bolts
Raise the end of the generator where the recoil starter is located high enough to gain access to the frame bottom; securely position props underneath to support.
Align the holes on the frame support with the holes on the generator frame.
Slide a washer on the bolt, then insert the bolt through the hole in the generator frame so it extends down through the frame support.
Install flange nut and tighten securely.
Repeat on other side.