assembly
installing the wheels
See Figure 3.
Wheels are provided to assist in moving the generator to the desired location and should be installed on the side opposite the handle.
Locate the following items:
2 bolts
6 washers (3/8 in.)
2 spacers (.38 ID)
2 wheels
2 lock nuts
Raise the end of the generator opposite the handle high enough to gain access to the frame bottom; securely position props underneath to support.
Insert a wheel spacer into the center of the wheel.
Place a washer on the bolt, then slide bolt through the wheel.
Thread another washer on the bolt, then slide the bolt through the
Place a washer on end of bolt.
Install nut on bolt and tighten securely.
Repeat the process on the other side to install second wheel.
securing the handle
See Figures 4 - 5.
Locate the following items: Handle lock pin Lanyard
Attach the lanyard to the handle lock pin and the handle as shown in figure 4.
Insert the pin through the hole in the handle and the generator frame to secure handle in place.
warning:
Do not attempt to lift the unit by the handle assembly. If it is necessary to lift the generator, always grasp by the frame. Use proper lifting techniques to avoid back injury.
lock
washer
lanyard
handle
lock pin
frame
handle hole lock pin
wheel
wheel
spacer
bolt
washer Fig. 3
frame
Fig. 4
handle
Fig. 5