ASSEMBLY
UNPACKING
This product requires assembly.
nCarefully cut the box down the sides then remove the product and any accessories from the box. Make sure that all items listed in the packing list are included.
WARNING:
Do not use this product if any parts on the Packing List are already assembled to your product when you unpack it. Parts on this list are not assembled to the product by the manufacturer and require customer installation. Use of a product that may have been improperly assembled could result in serious personal injury.
NOTE: This product is heavy. To avoid back injury, lift with your legs, not your back, and get help when needed.
nInspect the product carefully to make sure no breakage or damage occurred during shipping.
nDo not discard the packing material until you have care- fully inspected and satisfactorily operated the product.
nIf any parts are damaged or missing, please call
PACKING LIST
Pressure Washer
25 ft. High Pressure Hose Trigger Handle
Spray Wand
Hitch pins (2) Washers (2) Wheels (2) Handle Operator’s Manual
WARNING:
If any parts are damaged or missing do not operate this product until the parts are replaced. Use of this product with damaged or missing parts could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create acces- sories not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause serious personal injury, always disconnect the engine spark plug wire from the spark plug when assembling parts.
attaching the wheel assembly
See Figure 2.
nLocate the following items:
Axle (2) Hitch pins (2) Washers (2) Wheels (2)
nSlide the axle through the hole in the center of the wheel.
nSlide a washer onto the axle.
nLift the machine and slide the axle into the wheel mount- ing hole in the machine base as shown.
nPush the hitch pin into the hole on the end of the axle to secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until the center of the pin rests on top of the axle.
nRepeat with the second wheel.
INSTALLing the handle
See Figure 3.
To install the handle:
nPush and hold the button on the handle as you slide the handle into the holes in the frame.
NOTE: Before use, pull the handle up until the lock button snaps through the locking slot to secure the handle in place.
connecting high pressure hose to
TRIGGER HANDLE
See Figure 4.
nPull back and hold the collar on the high pressure hose.
Insert the inlet coupler on the trigger handle into the collar.
nRelease the collar and push until it locks into place.Pull on the hose to be certain it is properly secured.
Page 7 — English
