ASSEMBLY

assembling the trigger handle

See Figure 5.

To attach the spray wand:

nPlace the threaded end of the spray wand in the connector on the end of the trigger handle.

nTurn the connector clockwise until it stops. This secures the spray wand in place.

connecting the high pressure hose to the pump

See Figure 6.

After the high pressure hose has been uncoiled and attached to the trigger handle:

nPull back and hold the spring loaded collar on the pump.

nInsert the nozzle on the end of the high pressure hose into the collar.

nRelease the collar.

nPull on the hose to be certain it is properly secured.

connecting the garden hose to the pressure washer

See Figure 7.

caution:

Always observe all local regulations when connnecting hoses to the water main. Some areas have restrictions against connecting directly to public drinking water sup- ply to prevent the feedback of chemicals into the drinking water supply. Direct connection through a receiver tank or backflow preventer is usually permitted.

The water supply must come from a water main. NEVER use hot water or water from pools, lakes, etc. Before connecting the garden hose to the pressure washer:

nRun water through the hose for 30 seconds to clean any debris from the hose.

nInspect the screen in the water intake.

nIf the screen is damaged, do not use the machine until the screen has been replaced.

nIf the screen is dirty, clean it before connecting the garden hose to the machine.

To connect the garden hose to the machine:

nUncoil the garden hose.

NOTE: There must be a minimum of 10 feet of unre- stricted hose between the pressure washer intake and the hose faucet or shut off valve (such as a “Y” shut off connector).

nWith the hose faucet turned completely off, attach the end of the garden hose to the water intake. Tighten by hand.

attaching INJECTION hose

See Figure 8.

Before detergent can be used with this machine, the injection hose must be attached.

nPush the open end of the clear injection hose securely over the fitting as shown.

nPlace the filtered end of the injection hose in the bottle of detergent.

Page 8 — English

Page 12
Image 12
Homelite HL80923 Assembling the trigger handle, Connecting the high pressure hose to the pump, Attaching Injection hose