MAINTENANCE
6.Lay out the saw chain in a loop and straighten any kinks. The cutters should face in the direction of chain rotation. If they face backwards, turn the loop over. See Figure 45.
7.Place the chain drive links into the bar groove as shown in figure 46.
8.Position the chain so there is a loop at the back of the bar.
9.Hold the chain in position on the bar and place the loop around the sprocket.
10.Fit the bar flush against the mounting surface so that the bar studs are in the long slot of the bar.
Note: When placing the bar on the bar studs ensure that the adjusting pin is in the chain tension pin hole.
CUTTERS | CHAIN ROTATION |
CHAIN DRIVE LINKS
Fig. 44
Fig. 45
CHAIN DRIVE LINKS
BAR STUDS
ADJUSTING PIN
GUIDE BAR
PLATE
SPROCKET
BAR
GROOVE
Fig. 46
CLUTCH
COVER
Fig. 47
Page 23
