Homelite UT10927A Bar And Chain Combinations, Troubleshooting, Length of Bar, Chain Part Number

Models: UT10927A

1 36
Download 36 pages 53.16 Kb
Page 33
Image 33
BAR AND CHAIN COMBINATIONS

BAR AND CHAIN COMBINATIONS

 

Length of Bar

Guide Bar Part Number

Chain Part Number

 

16 in.

UP08676

UP08677

 

18 in.

UP08679

UP08680

 

 

 

 

 

 

TROUBLESHOOTING

 

 

 

 

 

 

 

 

 

 

 

 

 

 

PROBLEM

POSSIBLE CAUSE

SOLUTION

Engine will not start. (Make sure ignition switch is in start position “I”.)

1.No spark.

2.Flooded engine.

1.Check spark. Remove air filter cover. Remove spark plug from cylinder. Reattach the spark plug wire and lay spark plug on top of cylinder with the metal part of plug touching the cylinder. Pull the starter rope and watch for spark at spark plug tip. If there is no spark, repeat test with a new spark plug.

2.With the ignition switch off, remove spark plug. Move choke lever to run position (pushed in com- pletely) and pull starter cord 15 to 20 times. This will clear excess fuel from engine. Clean and reinstall spark plug. Set ignition switch to run (I) position. Push and fully release primer bulb 7 times. Pull starter three times with choke lever at run. If engine does not start, move choke lever to choke and repeat normal starting procedure. If engine still fails to start, repeat procedure with a new spark plug.

Engine starts but will

Carburetor requires “L” (Low jet)

Contact a Homelite Service Center for carburetor

not accelerate properly.

adjustment.

adjustment.

 

 

 

Engine starts but will

Carburetor requires “H” (High jet)

Contact a Homelite Service Center for carburetor

not run properly at high

adjustment.

adjustment.

speed .

 

 

 

 

 

 

 

 

 

Engine does not reach

1.

Check oil fuel mixture.

1.

Use fresh fuel and the correct 2-cycle oil mix ratio.

full speed and/or emits

2.

Air filter dirty.

2.

Clean air filter. Refer to “Maintenance – Cleaning

excessive smoke.

 

 

 

the Air Filter” earlier in this manual.

 

3.

Spark arrester screen dirty.

3.

Clean spark arrestor screen. Refer to “Maintenance

 

 

 

 

– Cleaning the Spark Arresting Muffler” earlier in

 

4.

Carburetor requires “H” (High

 

this manual.

 

 

jet) adjustment.

4.

Contact a Homelite Service Center for carburetor

 

 

 

 

adjustment.

 

 

 

 

 

Page 33

Page 33
Image 33
Homelite UT10927A Bar And Chain Combinations, Troubleshooting, Length of Bar, Guide Bar Part Number, Chain Part Number