OPERATION
WARNING:
Always hold the string trimmer away from the body keeping clearance between the body and the string trimmer. Any contact with the string trimmer cutting head while operating can result in serious personal injury.
ADVANCING lines
NOTE: The trimmer is equipped with an
With the trimmer running, release the switch trigger.
Wait two seconds, and press the switch trigger.
NOTE: The line will extend approximately 1/4 in. with each stop and start of the switch trigger until the line reaches the length of the grass deflector blade.
Resume trimming.
ADVANCING THE Line MANUALLY
Disconnect the string trimmer from the power supply, then push the spool retainer button in while pulling on trimmer line to manually advance.
CUT OFF BLADE
This trimmer is equipped with a
CUTTING TIPS
See Figure 10.
Keep the trimmer tilted toward the area being cut; this is the best cutting area.
The string trimmer cuts when passing the unit from left to right. This will avoid throwing debris at the operator. Avoid cutting in the dangerous area.
Use the tip of the line to do the cutting; do not force line head into uncut grass.
Wire and picket fences cause extra line wear, even break- age. Stone and brick walls, curbs, and wood may wear trimmer line rapidly.
Avoid trees and shrubs. Tree bark, wood moldings, siding, and fence posts can easily be damaged by the trimmer line.
TELESCOPING Shaft
See Figure 11.
The shaft can be extended or shortened for ease of use.
Unplug the string trimmer.
Unscrew telescoping shaft coupler and slide to desired position.
Tighten telescoping shaft coupler.
ROTATING rear HANDLE
See Figure 12.
Unplug the string trimmer.
Pull up edging coupler and turn handle end counterclockwise.
Release edging shaft coupler when handle has been rotated 180° and locks into place.
edging
See Figures 13 - 14.
The rotating handle can be used in combination with the edger guide for edging sidewalks and walkways. To use the edger guide, flip down from it’s stored position.
Page 9 — English
