WARRANTY
When warranty repair is needed, the engine must be brought to an authorized service dealer or warranty station’s place of business during normal business hours. In all cases, a reasonable time, not to exceed 30 days, must be allowed for the warranty repair to be completed after the engine is received by the authorized service dealer or warranty station.
MAINTENANCE, REPLACEMENT AND REPAIR OF
Only warranted engine replacement parts approved by ROBIN AMERICA should be used in the performance of any warranty maintenance or repairs on
PARTS COVERED UNDER THE CALIFORNIA EMISSIONS WARRANTY
The repair or replacement of any warranted part otherwise eligible for warranty coverage may be excluded from such warranty coverage if ROBIN AMERICA demonstrates that the engine has been abused, neglected, or improperly maintained, and that such abuse , neglect , or improper maintenance was the direct cause of
HIGH ALTITUDE ENGINE OPERATION■
the need for repair or replacement of the part. That notwithstand- ing, any adjustment of a component that has a factory installed, and properly operating, adjustment limiting device is still eligible for warranty coverage. The following emissions warranty parts list are covered.
(1)Fuel Metering System
(i)Carburetor and internal parts (and/or pressure regulator or fuel injection system)
(ii)Air/fuel ratio feedback and control system, if applicable
(iii)Cold start enrichment system, if applicable.
(iv)Regulator assembly (gaseous fuel, if applicable)
(2)Air Induction System
(i)Intake manifold, if applicable
(ii)Air filter
(3)Ignition System
(i)Spark plugs
(ii)Magneto or electronic ignition system
(iii)Spark advance/retard system, if applicable
(4)Exhaust manifold, if applicable
(5)Evaporation Systems
(i)Fuel lines
(ii)Fuel line fittings
(iii)Carbon canister
(iv)Canister mounting brackets
(v)Carburetor purge port connector
(vi)Fuel tank
(vii)Fuel cap
(viii)Clamps
Please have an authorized Robin America service dealer modify this engine if it is to be run continuously above 5000 feet (1500 meters). Failure to do so, may result in poor engine performance, spark plug fouling, hard starting, and increased emissions.■
Carburetor modification by an authorized Robin America service dealer will improve performance and allow that this engine meets EPA (Environmental Protection Agency) and California ARB (Air Resources Board) emission standards throughout its useful life.■
An engine converted for high altitudes can not be run at 5000 feet or lower. In doing so, the engine will overheat and cause serious engine damage. Please have an authorized Robin America service dealer restore high altitude modified engines to the original factory specification before operating below 5000 feet.
AIR INDEX
To show compliance with California emission regulations, a hangtag has been provided displaying the Air Index level and durability period of this engine.
The Air Index level defines how clean an engine’s exhaust is over a period of time. A bar graph scaled from “0” (most clean) to “10” (least clean) is used to show an engine’s Air Index level. A lower Air Index level represents cleaner exhaust from an engine. The period of time (in hours) that the Air Index level is measured is known as the durability period. Depending on the size of the engine, a selection of time periods can be used to measure the Air Index level (see below).
Descriptive Term | Applicable to Emissions Durability Period |
Moderate | 50 hours (engine from 0 to 80 cc) |
| 125 hours (engine greater than 80 cc) |
Intermediate | 125 hours (engine from 0 to 80 cc) |
| 250 hours (engine greater than 80 cc) |
Extended | 300 hours (engine from 0 to 80 cc) |
| 500 hours (engine greater than 80 cc) |
NOTICE: This hangtag must remain on this engine or piece of equipment, and only be removed by the ultimate purchaser before operation.
Valve Clearance | 0.12 mm (0.0047 in.) |
(Intake and Exhaust) | NOTE: Adjust the valve clearance while the engine is cold. |
Emissions Durability Period | 500 hours |
(California only) |
|
| 19 — English |
