TROUBLESHOOTING
PROBLEM |
| CAUSE |
| SOLUTION | |
Engine fails to start | 1. | No fuel in tank | 1. | Fill tank | |
| 2. | Engine switch in OFF position | 2. | Turn engine switch to ON position | |
| 3. | Spark plug shorted or fouled | 3. | Replace spark plug | |
| 4. | Spark plug is broken (cracked | 4. | Replace spark plug | |
|
| porcelain or electrodes broken) |
|
| |
| 5. | Ignition lead wire shorted, broken, | 5. | Replace lead wire or attach to spark plug | |
|
| or disconnected from spark plug |
|
| |
| 6. | Ignition inoperative | 6. Contact authorized service center | ||
|
|
|
|
| |
Engine hard to start | 1. | Water in gasoline | 1. | Drain entire system and refill with fresh fuel | |
| |||||
| 2. | Weak spark at spark plug | 2. | Contact authorized service center | |
|
|
|
|
| |
Engine lacks power | 1. | Dirty air filter | 1. | Clean or replace air filter | |
|
|
|
|
| |
Detergent fails to mix with | 1. | Detergent injection hose is not | 1. | Insert injection hose into detergent | |
spray |
| properly submerged |
| container or detergent bottle | |
| 2. | High pressure nozzle attached | 2. | Use Soap Blaster™ Nozzle to apply | |
|
|
|
| detergent | |
Pump doesn’t produce | 1. | Low pressure nozzle installed | 1. | Replace with high pressure nozzle | |
pressure | 2. | Inadequate water supply | 2. | Provide adequate water flow | |
| |||||
| 3. Trigger handle or spray wand leaks | 3. | Check connections and / or replace trigger | ||
|
|
|
| handle or spray wand | |
| 4. | Nozzle is clogged | 4. | Clean nozzle | |
| 5. | Pump is faulty | 5. | Contact authorized service center | |
| 6. | Air in line | 6. | Squeeze trigger on trigger handle to remove | |
|
|
|
| air from line | |
Machine doesn’t reach high | 1. | Diameter of garden hose is too small | 1. | Replace with 3/4 in. garden hose | |
pressure |
|
|
|
| |
| 2. | Water supply is restricted | 2. | Check garden hose for kinks, leaks, and | |
|
|
|
| blockages | |
| 3. | Not enough inlet water | 3. | Open water source full force | |
| 4. | Wrong nozzle is attached | 4. | Attach the high pressure nozzle | |
| 5. | Air in hose causing spray bar to turn | 5. | Disconnect trigger handle and let water run | |
|
| too slowly |
| until steady stream | |
|
|
|
|
| |
Striping, swirl patterns, | 1. | Pace is too fast | 1. | Slow your pace | |
or other marks appear in | 2. | Surface cleaner brush skirt bristles | 2. | Replace surface cleaner brush skirt | |
cleaned surface | |||||
| are worn |
|
| ||
|
|
|
| ||
| 3. | Feet on frame assembly are worn | 3. | Replace frame assembly feet | |
| 4. | Air in hose causing spray bar to turn | 4. | Disconnect trigger handle and let water run | |
|
| too slowly |
| until steady stream | |
|
|
|
|
| |
16 — English
