LOADER REMOVAL AND INSTALLATION
Start the tractor and shift the loader control
valve into the “float” position.
Slowly retract the bucket cylinders until the
bottom of the bucket rests firmly on the
ground.
Note: During this procedure the loader should
raise off the rear mount. If necessary, extend
the lift cylinders as required to raise the loader
clear of the rear mount.
Back the tractor slowly until the loader front
crosstube is just clear of the Front Mount.
Observe the hydraulic hoses
(valve/tubelines) to ensure they are not
caught or stretched during this operation
- Shift the loader control valve into the neutral
position.
Check to ensure the loader will clear the front
.tires. If additional clearance is required,
extend the lift cylinders.
Shut tractor OFF and disconnect the
hydraulic hose couplers. Secure the hydraulic
hoses to ensure they will be clear of the
tractor. Install dust caps and plugs.
Start the tractor and carefully back out of the
loader.
32