3.MOWING AND MULCHING RECOMMENDATIONS
GRASS CUlTlNG BASICS
Cutting Height
A cutting height setting of
Most grasses should be cut when they have grown 1/2 to 1 inch above the recommended height. If your grass gets too tall, cut it back a little at a time, allowing a few days for the grass to recover between mowings. Avoid cutting more than one third of total grass height in any one mowing.
For best mulching results, mow the lawn frequently enough that you will need to cut off less than one inch. Frequent mowing, with light cuts, makes it easier for your mulching mower to turn grass clippings into fine particles that will fall through the turf and decompose quickly.
Cutting Width
For an even lawn finish, overlap each mowing swath by a few inches. If the grass is very tall or thick, use more overlap and a narrower mowing swath. If clogging or clumping occurs, you may also need to mow more slowly or raise the cutting height setting.
Blade Speed
For best performance, the blade must spin very fast. Always use the fast throttle setting, and keep the engine running at or near maximum rpm. If you hear engine speed decrease, mow more slowly, cut a narrower swath, or raise the cutting height setting.
Blade Sharpness
Keep the blade sharp. A sharp blade cuts cleanly. A dull blade tears the grass, leaving shredded ends that turn brown.
Moisture
Always wait for wet grass to dry. Wet grass clippings will clog the mower deck and collect in clumps on the lawn.
If the soil is very dry, mowing can stir up a lot of dust. Besides being unpleasant to work in, too much dust will clog the carburetor air filter. If dust is a problem, water your lawn the day before mowing. Mow when the grass dries, and the soil is still moist.
8
