1.DEALER INSTALLATIONINSTRUCTIONS
3. Temporarily install the cover plate on the mower deck, using two 8 mm lock nuts.
A- COVER PLATE
4.Hold swirl guide B against the cover plate.
Insert a pencil through the holes in swirl guide B to mark drilling points on the cover plate.
Removethe cover platefrom the mower deck. Center punch and drill the cover plate at the pencil marks.
Use an 11/32 inch (8.4 - 8.7 mm) drill. Wear eye protection when drilling.
Remove any burrs from the holes.
SWIRL GUIDE B HOLES
5. Install the cover plate on the mower deck, using two 8 mm lock nuts.
Attach swirl guide B to the cover plate, using two 8 x 35mmflange bolts, 8 mmflat washers, and 8 mm lock nuts.
Install the bolts from inside the mower deck. Install the nuts outside the mower deck. Use washers on both sides, as shown.
Tighten all 8 mm nuts and bolts to a torque value of 15.2
8 mm LOCK
SWIRL GUIDE B
FANGE BOLT
COVER PLATE
6.Place swirl guide A in the mower deck, with one end against swirl guide B.
While holding swirl guide A in place, drill the first hole in the mower deck, using the hole in swirl guide A as a drill guide.
Use a 1/4 inch (6.2 - 6.4 mm) drill. Wear eye protection when drilling.
Remove any burrs from the hole.
3
