MAINTENANCE & ADJUSTMENTS
12. Release the parking brake. Remove the drive belt from the
pulley on the clutch tensioner arm. Flemove the drive belt
from the pulley on the engine and the transmission pulley.
Inspect the drive belt for excessive wear, cracks or other
damage. If needed, replace with a genuine Honda belt.
Installation of the new drive belt is the reverse of removal.
Use the illustration shown here for proper belt routing and
spacing. Be sure the belt holders all1 have 1 - 3 mm
(l/l 6 inch) clearance as shown.
Before tightening the belt guide on the clutch pulley, make
sure the alignment tab on one side ‘of the guide is properly
inserted into the guide hole on the t<ensioner arm.
l-3mm
92