COOLANT
Coolant Level
Check the coolant level in the reserve tank when the engine is at normal
operating temperature. It should be between the MAX and MIN marks.
If the coolant level is near the MIN mark, add coolant to bring it up to the MAX
mark.
If there is no coolant in the reserve tank, the cooling system should be checked
for leaks and repaired if necessary. Coolant must then be added to the radiator
and reserve tank.
m The coolant is hot and under pressure and severe scalding could
result. Never remove the radiator cap when the engine is hot.
Wait until the engine is cool, then turn the radiator cap counterclockwise until
it stops. DO NOT PRESS DOWN WHILE TURNING THE CAP. After any remaining
pressure has been relieved, remove the cap by pressing down and again turning
it counterclockwise.
Add enough coolant to fill the radiator, and reinstall the cap. Fill the reserve tank
once the engine reaches normal operating temperature.
Coolant Recommendation
Use high quality ethylene glycol antifreeze that is specifically formulated
for use in aluminum engines. Mix the antifreeze with low-mineral drinking
I water or distilled water.
A 50/50 mixture of ethylene glycol antifreeze and water is recommended
for most temperatures and provides good corrosion protection. A higher
concentration of antifreeze decreases cooling efficiency and is recom-
mended only if additional protection against freezing is needed. A concen-
tration of less than 40% antifreeze will not provide proper corrosion
protection.
(1 The use of unsuitable antifreeze, hard water, or salt water may
cause corrosion damage that will shorten the life of the engine.
CAP COOLANT
MAX
(UPPER LIMIT1
MIN
ILOWER LIMIT)
I RESERVE TANK 25