Blade Installation
-1 Use a genuine Honda replacement blade or equivalent.
- 1. Clean dirt and grass from the blade, blade holder, and the inside of
the cutter deck.
-2. Install the blade holder, blade, washer, and blade bolts.
38 inch cutter deck only:
NOTE: Right and left blades are not interchangeable. Be sure to install the
high-lift blade on the right (discharge side) and the low-lift blade on the left
sides, as shown.
38 inch type 42 inch type
lift
Be sure the blade is properly aligned with the blade holder before tighten-
ing the blade bolt. Do not allow the blade to overlap the edge of the holder.
. Install the blades with the lift section of the blade toward the cutter
deck as shown.
. Install the washer with the side marked “INSIDE” facing the blade.
. The blade bolt and washer are specially designed for this application
and must not be replaced with any other bolt or washer.
-3. Hold the blade firmly, and tighten the blade bolt to a torque value of
58 N.m (6.0 kg-m, 43.4 ft-lb).
71