Battery Cleaning
If the batterv terminals are contaminated or corroded, remove the battery
and clean the terminals.
1. Remove the battery set plate.
2. Disconnect the battery cable at the
at the battery positive (+I terminal.
battery negative (-1 terminal, then
BATTERY SET PLATE
NEGATIVE I-) TERMINAL
WSlllVE (+) TERMINAL
3. Remove the battery and clean the battery terminals and battery cable
terminals with a wire brush or sand paper.
Clean the battery with a solution of baking soda and warm water, tak-
ing care not to get the solution or water in the battery cells. Dry the bat-
tery thoroughly.
4. Connect the battery positive (+I cable to the battery positive (+) ter-
minal, then the battery negative (-1 cable to the battery negative (-1
terminal. Tighten the bolts and nuts securely.
5. Coat the battery terminals with grease.
6. Reinstall the battery set plate.
m When disconnecting the battery cable, b8 sure to disconnect at
the battery negative (-1 terminal first. To connect, connect at the positive
(+l terminal first, then at the negative 1-l terminal. Never disconnect the battery
cable in the reverse order, or it causes a short circuit when a tool contacts the
terminals.
62