Honda Power Equipment H6522 n

n Battery cleaning

If the battery terminals are contaminated or corroded, remove the battery

and clean the terminals.

Removal:

1. Open the engine hood and remove the hood (see page 39).

2. Remove battery hold down.

3. Disconnect the negative (-1 battery cable first, then disconnect the

positive (+I battery cable.

4. Remove the battery.

5. Clean the terminals with a wire brush or sand paper. Clean the battery

with a solution of baking soda and warm water, taking care not to get

the solution of water in the battery cells. Dry the battery thoroughly.

Clean the battery cable ends with a wire brush or sand paper.

EGATIVE I-1 TERMINAL

BATTERY HOLD DOWN

Installation:

1. Install the battery into the tractor.

2. Connect the positive (+) battery cable first and tighten the nut securely.

Slide the battery boot over the positive (+) cable and terminal.

3. Connect the negative (-1 battery cable. Tighten the nut securely.

4. Coat the battery terminals and cable ends with clean grease.

5. Reinstall the battery hold down.

6. Reinstall the engine hood (see page 39).

105

Contents

Main Page Page CONTENTS 3. Coolant temperature gauge ............................................. 18 2 Page Page 1. SAFETY INFORMATION .ji$ I-~ DEeEL \ AWARNING (1) Page Page Page Page Page Page Page 3. COMPONENT IDENTIFICATION 14 Page 4. CONTROLS INSTRUMENT PANEL 16 / Page Page Page Page Page Page Page Page m Page Page Page Page -1 . . . . . . . . . . -1 m Page Page Page 5. PRE-OPERATION CHECKS 35 Page Page Page Page Page 2. Open the hood and clean the engine block around the dipstick. Remove 30 1 TEMP -20 -10 0 10 20 30 40-C I I I I I , 0 20 40 60 80 100F Page m Page Page Page Page 48 Page Page Page Page Page Page Page -\ &@ Page Page Page Page Page f3hcE Page Page Page Page Page m Page Page Page m-1 CO/TERwE,GHT TABLE. Size and Weight Limits by Attachments Page Page Page Page Page Page Page m Page 7. TRANSPORTING 82 Page 8. INSTALLING AN ATTACHMENT 84 %I II TURNBUCKLE / 12 85 Page Page 9. MAINTENANCE 88 Page 2. Maintenance schedule Banery Page m Page Page Page Page Page Page Page Page Page Page Page Page n Page Page Page Page 10. LONG TERfUi STORAGE m 110 m 5. Change the engine oil and run the engine for five minutes so that the oil Page 11. UROUBLESHOOTIBUG 112 Page l-ziimq 12. SPECIFICATIONS DIMENSION 115 ENGINE FRAME . 13. WARRANTY SERVICE Current customer service contact information: United States, Puerto Rico, and U.S. Virgin Islands: