Honeywell 3-144C manual Walk Test User Type 2.5 and Above, Selecting Walk Test, All Zones, Purpose

Walk Test (User Type 2.5 and Above)

PIN + ent

0 = OMIT ZONES [ent] to Select

6

6 = Walk Test ent to select

ent

1=TEST ALL ZONES 2=SELECTED ZONES

1

WALK TEST ACTIVE ESC to abort

NO ENTRIES

2

1001 FINAL

#=TEST ENT=START

>A

1002 EXIT

#=TEST ENT=START

#

1002 EXIT

TEST ENT=START

ent

Purpose

The Walk Test option provides a method of testing the zones to ensure that they are operating correctly. There are two options available:

1. All zones can be tested

2. Selected zones can be tested

In both cases the sounder indicates an open zone. The test is recorded in the log. Wire-free zones also show the received signal strength as a percentage

Selecting Walk Test

Enter the QUICK MENU. Press the key 6 followed by the ent key. When Walk Test is selected, Test All Zones or Selected Zones displays.

All Zones

Choosing All Zones (press key 1) starts the test immediately. No selection is necessary as all valid zones are included in the test. The sounder operates whenever a zone is opened and stops when all zones are closed.

Note: The Test All Zones option only tests zones which can be omitted from the system.

Selected Zones

Choosing the Selected Zones option by pressing key 2 displays the first zone on the system. Each zone is displayed in turn by using the >A or <B keys. When the zone to be included in the test is displayed, press the # key. Other zones can be included in the test in the same manner. When all of the required zones have been selected, press the ent key to start the Walk Test.

Note: The Selected Zones option includes non-omittable zones.

Ending Walk Test

To abort the walk test option press the esc key, otherwise the walk test option remains active for 20 minutes after the last key press.

15