Honeywell 600, 400, 624 Keypad Sounder, Miscellaneous Commands cont, To change the keypad sounder

Miscellaneous Commands (cont)

OMNI-LCD or OMNI-LCD-US:Press and hold down the INSTANT / and

CODE / keys at the same time for about two seconds. Press the 1

key to toggle the display between:

Backlight 120s time out …. and …. Backlight Always On

Press the [✱] key to exit this Backlight menu.

KEYPAD SOUNDER

The sounder (or loudspeaker) housed inside the keypad emits (annunciates) sounds according to the condition of the security system. If you are using an OMNI-KP, OMNI-KP-US, OMNI-LCD, or OMNI-LCD-US keypad, the sounds from the keypad sounder can be controlled.

To change the keypad sounder:

OMNI-KP or OMNI-KP-US: Press the BYPASS / and CODE / keys

at the same time and hold down for two seconds until you hear a beep. Press any key (except the Tkey) to toggle the sounder on or off.

0 = Sounder off 1 = Sounder on Press the [✱] key to exit the sounder menu.

OMNI-LCD or OMNI-LCD-US:There are four modes available in the Sounder Menu. They are as follows:

•On – Normal Sounder Keys (all sounds on)

•Key – Only Key Clicks

•Fire – Only Fire Sounder (temporal sounder – not supported by all systems)

•Off – No Sounds at all

To use the OMNI-LCD or OMNI-LCD-US sounder menu:

1. Press the BYPASS / and CODE / keys at the same time and

hold down for two seconds. This accesses the Sounder Menu.

2. Press the	1	key to toggle through the four modes listed above (stop at
desired mode).
3. Press the	2	key to toggle through the sounder volume choices (high or low
appears on the display).
4. Press the	3	key to adjust the sound of the key acknowledge (Ack H or L

appears on the display).

5. Press the Tkey to exit the Sounder Menu.

- 21 -