Honeywell 848, 400, 600, 624 manual Using a Pager cont, Turn Pager Reporting On/Off For A User

Using a Pager (cont)

The [#], [5], [8] command is accessible only while the system is disarmed and the dialer, dialer delay, and bell are not active.

In pager phone number programming mode, only the LCD keypad provides visual display of the numbers already programmed or numbers that are being changed. The LED and fixed-word style keypads provide no visual keypad display of these numbers.

2.Enter your new pager phone number. Your new pager phone number may consist of up to 16 characters (1-9, 0). It may be necessary to add time to allow the pager to answer before dialing your pager number. To enter a 2-second

pause, press the CODE / key. (Entering a 2-second pause is optional

and is not required to enter your pager phone number.) If the CODE/ key was pressed, it counts as one character. The keypad will emit a single acknowledgement chirp as each number is pressed.

3. Press the # key after you have made your pager phone number changes.

Pressing the [#] key saves your new pager number and nulls out the remaining locations. An acknowledgement tone sounds.

To exit without saving changes, press the Tkey to exit pager phone number

programming. An acknowledgement tone sounds to indicate pager number programming has been exited.

If you press the [✴] key without first pressing the [#] key to save your new pager phone number, the system exits the pager phone number programming mode without saving the changes.

If no key is pressed within 10 seconds, the pager phone number programming mode times out and exits automatically without saving any information entered.

TURN PAGER REPORTING ON/OFF FOR THE PARTITION (OMNI624 and 848 ONLY) You can turn on/off the open-close reporting feature for a partition by pressing

# , 8 . The display prompts you to toggle the feature on/off with the

#key. To exit, press the Tkey.

TURN PAGER REPORTING ON/OFF FOR A USER

You can turn on/off the open-close reporting feature for a user by entering the following :

# , 7 , [master code] [user number] [4]

NOTE: The [#], [7] command is also used to assign a user to a different partition for the OMNI624 and 848 only (see ASSIGNING PARTITIONS TO USERS on page 15).

- 23 -