13

Maintenance

Repairs

Repairs and/or upgrades are not to be performed on this product. These services are to be performed only by an authorized service center (see Customer Support on page 14-1).

Maintenance

Your device provides reliable and efficient operation with a minimum of care. Although specific maintenance is not required, the following periodic checks ensure dependable operation:

Cleaning the Scanner

The scanner’s housing may be cleaned with a soft cloth or tissue dampened with water (or a mild detergent-water solution.)

If a detergent solution is used, rinse with a clean tissue dampened with water only.

!Caution:

Do not submerge the scanner in water. The scanner’s
housing is not watertight.

Do not use abrasive wipes or tissues on the scanner’s window – abrasive wipes may scratch the window. Never use solvents (e.g., acetone) on the housing or window – solvents may damage the finish or the window.

Cleaning the Window

Reading performance may degrade if the scanner’s window is not clean. If the window is visibly dirty, or if the scanner isn’t operating well, clean the window with one of the cleaning solutions listed below.

•Sani-Cloth®HB wipes

•Sani-Cloth®Plus wipes

•Super Sani-Cloth®wipes

•Isopropyl Alcohol wipes (70%)

•CaviWipes™

•Virex® 256

•409® Glass and Surface Cleaner

•Windex® Blue

•Clorox® Bleach – 10%

•Gentle dish soap and water

Inspecting Cords and Connectors

Inspect the interface cable and connector for wear or other signs of damage. A badly worn cable or damaged connector may interfere with scanner operation. Contact your distributor for information about cable replacement. Cable replacement instructions are on page 13-1.

Replacing Cables in Corded Scanners

The standard interface cable is attached to the scanner with an 10-pin modular connector. When properly seated, the connector is held in the scanner by a flexible retention tab. The interface cable is designed to be field replaceable.

•Order replacement cables from Honeywell or from an authorized distributor.

•When ordering a replacement cable, specify the cable part number of the original interface cable.

13 - 1