Configuration for EAS Applications
EAS support is disabled by default in the
1.Scan the system type bar code below to enable EAS system support.
Enable Checkpoint System EAS Support
³ 3 3 7 2 2 0
2.Scan either the Enable Continuous Mode bar code or the Enable Regular Mode bar code.
Regular Mode
In regular EAS mode, the imager will signal the EAS system to activate immediately after the area imager successfully transmits a bar code. The imager will also signal the EAS system to deactivate after the configured EAS timeout expires.
Note: If regular mode is enabled an EAS timeout length will need to be configured (see page 43).
Enable Regular Mode
³ 1 4 6 1 0 5
Continuous Mode
In continuous mode, the imager will signal the EAS system to activate when it first powers on. The area imager will never deactivate the EAS system while in continuous mode. The EAS timeout setting has no effect in continuous mode.
Enable Continuous Mode
³ 1 4 6 1 1 5
42