In this chapter... | |
Overview | 65 |
Adding a New NetAXS™ Panel | 66 |
3.1 Overview
This chapter explains the NetAXS™ configuration functions as accessed via the Quick Start Wizard (QSW) in WIN-PAK 2005, WIN-PAK PRO 2005, WIN-PAK SE, and WIN-PAK PE. The QSW creates the ADV options and adds the panel to the Control Map and the Master Access Level.
These functions should be performed only by the NetAXS™ system administrator or service personnel.
Notes:
• WIN-PAK 2.0, release 4, uses the same steps provided in this chapter to configure NetAXS™; however, its screens are not exactly the same.
•NetAXS™ cannot be added to WIN-PAK PRO Release 4 or older.
•For a new Site installation, or for adding to an existing Site, follow the procedures in this chapter as you would when you add an N-1000-IV-X panel. One exception to this is that the NetAXS™ panel does not support the use of the C-100-A1 (20ma current loop installations). Therefore, when you select the Loop type, 485 ACK<-NAK is the only supported type. Direct is reserved for NS2P; C-100 is not supported.
•If the NetAXS™ panel is configured as a Gateway panel, it appears to WIN-PAK as an N-485-PCI or N-485-HUB. Using the NetAXS™ panel as a Gateway, you should not add N-1000/PW-2000 panels as a downstream panel to the NetAXS™ gateway. The NetAXS™ gateway is designed for more efficient downstream communications than what can be supported by the N-1000/PW2000 panels.
NetAXS™ Access Control Unit User’s Guide, Document 800-04410, Revision A | 65 |