![](/images/new-backgrounds/1053120/5312041x1.webp)
Configuring via the Web Server
Configuring the System
2.2 Configuring the System
2.2.1 Host/Loop Communications Tab
In order to maintain your NetAXS™ system configuration or to monitor its status, you must connect to the NetAXS™ panel by using one of two modes:
•Host mode (monitor only) – a host software system, such as
•Web mode (configure and monitor) – the NetAXS™ web server connects to the panel and enables you to configure the panel and monitor system status.
This tab enables you to select and configure the communication mode you will use to connect to the panel.
Note: A Gateway panel installed with release 3.1.8 or newer of NetAXS™ firmware cannot communicate fully with previous versions of NetAXS™ that may be installed on existing panels. If your panels are running release 2 (v2.2.21 or older), they must be upgraded to release 3.
Click the Host/Loop Communications tab:
Figure 2-2: Configuration > System >Host/Loop Communications Tab
NetAXS™ Access Control Unit User’s Guide, Document | 11 |