Reboot

When the Windows desktop is displayed or an application begins, the power up (or reboot) sequence is complete.

Warm Boot

Start > Run

The Warm Boot function refreshes the Windows operating system without clearing RAM or deleting installed programs. User- set parameters are unchanged.

Tap Start > Run and type WARMBOOT.EXE or WARMBOOT. This command is not case sensitive. Tap the OK button. This process takes less than 15 seconds. Temporary data not saved is lost.

Note: There may be slight delays while the wireless client connects to the network, re-authorization for voice-enabled applications completes, Wavelink Avalanche management of the MX3Plus startup completes, or Bluetooth relationships establish or re-establish.

Cold Boot

Start > Run

The Cold Boot function reboots the device, erases all registry data, and user-specified settings. The factory default settings are restored when the MX3Plus powers on again.

Passwords are lost upon cold boot. If a password is set, that password must be entered to begin the cold boot power cycle process.

Tap Start > Run and type COLDBOOT.EXE or COLDBOOT. This command is not case-sensitive1. Tap the OK button.

Note: Because of the extreme nature of cold boot, Honeywell recommends using this command only as an emergency (or when instructed to do so as part of a specific MX3Plus procedure).

1The text typed in the text box can be upper or lower case or a combination of upper and lower case letters.

2-15