Honeywell HZC-855NX On Screen Display, Fig5-1. Operating OSD display position, 125, 0, 0 0

5. On Screen Display

⑧ ⑧

① ② ③,④ ⑤ ⑥

⑦ ⑧

<Fig5-1. Operating OSD display position>

5.1 How to display Operating OSD

a. Pressing the MENU key softly confirm current Operating OSD.

It is disappeared about five seconds later if there are no other key actions.

b. When it zoom in or out pressing TELE(up) or WIDE(down) key, whole Operating OSD is displayed and then disappeared. Press NEAR(+) , FAR(-) key, only upper part of Operating OSD

( for displaying camera mode ) is displayed and then disappeared. (It is for checking current whole camera mode and zoom position )

c. Even though Operating OSD is disappeared, it keep displaying ID in lower part of screen.

In order to do not display ID, one method is to change EEPROM data

of Camera, the other is to use external communication through RS-232C.

d.Using RS-232C communication, change display position of ID; Bottom Right -> Top Left -> Top Right -> Non display.

*If display Operating OSD is not needed by special purpose

like using external text overlay board, it can be OFF mode at all times through external communication control as RS 232C.

	FUNCTION	OSD Format			DESCRIPTION
	Focus Mode	Non display			Auto Mode
①				MF	Manual / Oneshot Mode
		Non display			Backlight OFF
②	Back Light			BL	Backlight ON
		Non display			Flickerless OFF
③	Flickerless			FL	Flickerless ON
		Non display			NTSC:1/60
④	Shutter Speed	1 /	.	125	9 variable steps
		1 /.5 0, 0 0 0
⑤		Non display			Nightshot OFF
	Night Mode			IR	Nightshot ON
		Non display			Auto Tracking WB mode
				IN	Indoor Preset (3200°K)
				OUT	Outdoor Preset (5400°K)
⑥
				MWB	Manual WB mode
	WB MODE
				AWC	One Push mode
				AWB	Auto WB mode
				x35	Optical Zoom
	ZOOM			Dx90	Digital Zoom
	DISPLAY			>> TELE	zoom IN
⑦
				<< WIDE	zoom OUT
		Non display			In case that ID is 0
⑧	CAMERA
				ID : 002	In case that ID is 1 ~ 255
	ID/TITLE
				TITLE	DISPLAY set as TITLE

- 10 -

<Table5-1. Operating OSD description>