INSTALLATION

RS232 or Light Pen

1.Turn off the host device.

2.Plug the male 10-pin RJ45 end of the PowerLink cable into the 10-pin socket on the MS3780.

3.Connect the 9-pin female end of the PowerLink cable to the appropriate communication port on the host device.

4.Plug the external power supply into the power jack on the PowerLink cable.

Check the AC input requirements of the power supply to make sure the voltage matches the AC outlet. The outlet must be located near the equipment and be easily accessible.

5. Connect AC power to the transformer.

6. Turn on the host device.

Figure 7.

When the scanner first receives power the white LED will flash, one blue LED will turn on and the scanner will emit one beep.

Plugging the scanner into the serial port of the PC does not guarantee that scanned information will appear at the PC. A software driver and correct configuration setting are also required for proper communication to occur.

See Caution statement on page 5.

7