Prestige™ Installation Guide

Link remote control to thermostat (optional)

CONNECT

WIRELESS SETUP

Press to link to

Press to save

another thermostat

and exit

YESNO

CONNECT MORE?

1Make sure the thermostat displays the “Add Device” timer (see page 9).

2Press CONNECT at the remote. There will be a short delay as the remote seeks a signal from the thermostat.

3When the screen displays “Connected,” press DONE.

4Press NO at the next screen to save and exit. (Or press YES and repeat steps 1-4 to link another thermostat.)

The linking procedure at the remote may time out if there is no keypress within 30 minutes. To begin again, press and hold the blank space (or arrow if present) in the lower right corner of the screen until the display changes (about 3 seconds).

Link outdoor sensor to thermostat (optional)

Press and release

1 Make sure the thermostat displays

 

the “Add Device” timer (see page 9).

2 Press the CONNECT button on the back of the sensor.

3 Check thermostat to verify that the outdoor sensor is working. After about 15 seconds, the thermostat should display outdoor temperature and humidity.

10