Duress Code

(Continued)

To Change Your Master Code

SECURITY CODES (Continued)

To program a Duress code:

Enter your Master Code + 8 + 8 + [desired 4-digit duress code]. The keypad will beep once.

Note: The Duress code must differ from the Master Code or any other User’s Code.

To change the Duress code:

Enter Master Code + 8 + 8 + [new 4-digit duress code].

To delete the Duress code:

Enter your Master Code + 8 + 8, and then stop. When the keypad beeps once it signifies that the code has been deleted.

1.Enter your Master code and press the CODE [8] key.

2.Enter “2”.

3.Enter your new Master code.

4.Enter your new Master code again. The keypad will beep 3 times, indicating acceptance.

Quick Arming

Ask your installer if "Quick Arming" is active for your system; if so, check here:

Phone Module

Ask your installer if your system includes a phone module; if so, check here:

If your system supports "Quick Arming", the "#" key can be pressed in place of the security code when arming the system. The security code is always required, however, when disarming the system.

If your system includes a phone module, your installer will have programmed a 2-digit phone access code for your system. Be sure to obtain this phone code from your installer.

Complete information regarding the use of this phone access feature is provided in a separate manual entitled PHONE ACCESS USER'S GUIDE, which accompanies the phone module.

– 1 1 –