Honeywell VM2 Wireless Network Configuration, SSID, Profile, EAP type, Auth Type, Encryption, Admin Login, Credentials

Refer to the Thor VM2 User’s Guide, available at www.honeywellaidc.com, for further information about ActiveSync information.

Wireless Network Configuration

If the access point uses an authentication protocol (WEP, LEAP, etc.), your radio must use the same authentication. Contact your IT department for any necessary keys, login credentials, or certificates. Refer to the Thor VM1 User’s Guide, available at www.honeywellaidc.com, for further information or for configuration options not listed here.

1.Tap Start > Programs > Summit > SCU or tap the Summit Client Utility icon on the desktop.

2.Tap the Admin Login button and enter the password (default = SUMMIT).

3.Tap the Profile tab and make sure the Default profile is selected.

4.Select SSID and enter the SSID of the access point.

5.If the access point is using WPA or WPA2:

5a. Set Encryption to WPA TKIP, WPA CCKM, WPA2 AES, WPA2-TKIP, or WPA2 CCKM.

5b. Set EAP type to PEAP/MSCHAP, PEAP/GTC, WPA/ LEAP, EAP-FAST or EAP-TLS.

5c. Set Auth Type to Open unless using WEP/LEAP. For WEP/LEAP set Auth Type to correspond to the access point’s setting.

5d. Tap the Credentials button and complete the entries on the popup screen.

5e. Tap OK. Skip to step 8.